Cabletron Systems DLE23-MA User Manual
Connecting to the Network
DLE22-MA, DLE32-MA, DLE23-MA and DLE33-MA User’s Guide
3-7
3.
Verify that a link exists by checking that the port RX LED is on
(flashing amber, blinking green, or solid green). If the RX LED is off,
perform the following steps until it is on:
(flashing amber, blinking green, or solid green). If the RX LED is off,
perform the following steps until it is on:
a.
Verify that the 10BASE-T device at the other end of the twisted
pair segment is ON and connected to the segment.
pair segment is ON and connected to the segment.
b. Verify that the RJ45 connectors on the twisted pair segment have
the proper pinouts (Figure 3-3) and check the cable for continuity.
Figure 3-3
Cable Pinouts - (RJ45) Crossover Cable
c.
Check that the twisted pair connection meets the dB loss and cable
specifications outlined in Chapter 2.
specifications outlined in Chapter 2.
If a link is not established, contact your DIGITAL representative.
4.
Repeat steps 1 through 3, above, until all connections have been made.
TX+
TX–
RX+
RX–
2
1
3
6
TO
10BASE-T Device Port
TX+
TX–
2
1
3
6
NOTE:
RX+/RX– and TX+/TX–
must share a common
color pair.
RX+/RX– and TX+/TX–
must share a common
color pair.
TO
SmartSwitch RJ45 Port
LKG-10875-98F
RJ45 to RJ45
RX+
RX–