Cabletron Systems TSX-1620 User Manual
Managing the Device
2-21
Using the TSX-1620 Hub View
5.
Designate the port’s flow control parameter by clicking on the menu button in
the Flow Control field to display the Flow Control selection menu. Select the
desired type of flow control (none, Rts-cts, or Xoff) from the menu. The menu
will disappear, and your selection will be displayed in the menu button.
the Flow Control field to display the Flow Control selection menu. Select the
desired type of flow control (none, Rts-cts, or Xoff) from the menu. The menu
will disappear, and your selection will be displayed in the menu button.
6.
Enable or disable the ANSI Graphics option for the port by clicking either the
Enable or Disable option in the Graphics Mode field.
Enable or Disable option in the Graphics Mode field.
Performing IF Configuration
The IF Config utility allows you to establish Bridge and IP parameters for each
port on your TSX-1620. Using the IF Configuration window, you can establish the
bridge type, enable or disable NetBIOS and Spanning Tree, assign a priority level,
and define or change the IP address, subnet mask, gateway address, and MAC
address for each interface (port) on your device. To launch the IF Configuration
window:
port on your TSX-1620. Using the IF Configuration window, you can establish the
bridge type, enable or disable NetBIOS and Spanning Tree, assign a priority level,
and define or change the IP address, subnet mask, gateway address, and MAC
address for each interface (port) on your device. To launch the IF Configuration
window:
1.
Click on the module index or module type to display the Module menu (see
2.
Drag down to Module Utilities, then right to IF Config, and release.
Figure 2-11. The IF Configuration Window