Cisco Systems WSC2960S24TSSRF User Manual
2-17
Catalyst 2960-S Switch Hardware Installation Guide
OL-19732-04
Chapter 2 Switch Installation
Connecting the FlexStack Cables
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis. Place the switch
on the table or shelf near an AC power source.
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis. Place the switch
on the table or shelf near an AC power source.
When you complete the switch installation, see the
for
information on switch configuration.
After Switch Installation
•
Configure the switch by running Express Setup to enter the initial switch configuration. See the
switch getting started guide in the
switch getting started guide in the
section.
•
Use the CLI setup program to enter the initial switch configuration. See
•
Connect to the stack ports. See the
.
•
Install the power cord retainer (optional). See the
•
Connect to the front-panel ports. See the
the
, and the
.
Connecting the FlexStack Cables
Always use a Cisco-approved FlexStack cable to connect the switches.
Note
Connect only Catalyst 2960-S switches in a switch stack.
Step 1
Remove the dust covers from the FlexStack cables, and store them for future use.
Figure 2-17
Connect the FlexStack Cables
2062
3
5