Cisco Systems WSC2960S24TSSRF User Manual

Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the 
cable into the stack port on the other switch. Make sure you insert the cables in completely until you feel 
them snap into place.

When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector. When 
you connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.

To remove a FlexStack cable, grasp the tab on the cable connector and gently pull straight out. When 
you remove the FlexStack cables from the connectors, replace the dust covers to protect them from dust. 

Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert the 
cable more often than is absolutely necessary.

The power cord retainer part number (PWR-CLP=) is optional. You can order it when you order your 
switch, or you can order it later from your Cisco representative.

Choose the sleeve size of the power cord retainer based on the thickness of the cord. The smaller sleeve 
can be snapped off and used for thin cords. See 

Slide the retainer around the AC power cord, and pass it around the loop on the switch. See 

.

AC power cord

 Sleeve for thinner power cords

Power cord retainer

Loop

RATING

100-240

~

12-6A, 50-60Hz

333871