DELL S6000-ON User Manual

  Input 0 IP Packets, 0 Vlans 0 MPLS

  0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts

  0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts

Received 0 input symbol errors, 0 runts, 0 giants, 0 throttles

  0 CRC, 0 IP Checksum, 0 overrun, 0 discarded

  0 packets output, 0 bytes, 0 underruns

  Output 0 Multicasts, 0 Broadcasts, 0 Unicasts

  0 IP Packets, 0 Vlans, 0 MPLS

  0 throttles, 0 discarded

  Input 00.00 Mbits/sec,  0 packets/sec, 0.00% of line-rate

  Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate

Time since last interface status change: 1d23h42m

Dynamic Counters

By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.

For the remaining applications, Dell Networking OS automatically turns on counting when you enable the 
application, and is turned off when you disable the application.

NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an 
impact on line rate performance.

The following counter-dependent applications are supported by Dell Networking OS:

• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB

Clearing Interface Counters

The counters in the show interfaces command are reset by the clear counters command. This 

command does not clear the counters any SNMP program captures.
To clear the counters, use the following the command.

• Clear the counters used in the show interface commands for all VRRP groups, VLANs, and physical 

interfaces or selected ones. Without an interface specified, the command clears all interface counters.
EXEC Privilege mode

clear counters [interface] [vrrp [vrid] | learning-limit]

(OPTIONAL) Enter the following interface keywords and slot/port or number information:

426

Interfaces