DELL S6000-ON User Manual
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/
subport information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then
– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then
the slot/port information. The slot range is from 1 to 6. The port range is 1.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a
number from 1 to 255 as the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC
learning limit on the interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, confirm that you want Dell Networking OS to clear the interface counters
for that interface.
for that interface.
Dell#clear counters te 1/1/1
Clear counters on TenGigabitEthernet 1/1/1 [confirm]
Dell#
Enhanced Validation of Interface Ranges
This functionality is supported on the platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as interface range fo 1/1-1,te 2/1/1, this configuration is considered valid. The comma-
separated list is not required to be separated by spaces in between the ranges. You can associate
multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-
table static multicast-mac-address vlan vlan-id output-range interface command.
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as interface range fo 1/1-1,te 2/1/1, this configuration is considered valid. The comma-
separated list is not required to be separated by spaces in between the ranges. You can associate
multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-
table static multicast-mac-address vlan vlan-id output-range interface command.
Compressing Configuration Files
The functionality to optimize and reduce the sizes of the configuration files is supported on the device.
You can compress the running configuration by grouping all the VLANs and the physical interfaces with
the same property. Support to store the operating configuration to the startup config in the compressed
mode and to perform an image downgrade without any configuration loss are provided.
the same property. Support to store the operating configuration to the startup config in the compressed
mode and to perform an image downgrade without any configuration loss are provided.
You can create groups of VLANs using the interface group command. This command will create
non-existant VLANs specified in a range. On successful command execution, the CLI switches to the
interface group context. The configuration commands inside the group context will be the similar to that
of the existing range command.
non-existant VLANs specified in a range. On successful command execution, the CLI switches to the
interface group context. The configuration commands inside the group context will be the similar to that
of the existing range command.
Two existing exec mode CLIs are enhanced to display and store the running configuration in the
compressed mode.
compressed mode.
Interfaces
427