DELL PC6224F User Manual

Ethernet Configuration Commands

• 10 — Configures the port to 10 Mbps operation.
• 100 — Configures the port to 100 Mbps operation.

This command has no default setting.

Interface Configuration (Ethernet) mode

This command has no user guidelines.

The following example configures the speed operation of Ethernet port 1/g5 

to force 100-Mbps operation.

console(config)#interface ethernet 1/g5

console(config-if-1/g5)#speed 100

Use the storm-control broadcast command in Interface Configuration mode 

to enable broadcast storm recovery mode for a specific interface. If the mode 

is enabled, broadcast storm recovery is active, and if the rate of L2 broadcast 

traffic ingressing on an interface increases beyond the configured threshold, 

the traffic will be dropped. Therefore, the rate of broadcast traffic will be 

limited to the configured threshold. 

rate]

• level— The configured rate as a percentage of link-speed.
•

rate — The configured rate in kilobits per second (kbps). (Range: 0-100)