DELL PC6224F User Manual

Ethernet Configuration Commands

Interface Configuration (Ethernet) mode

This command has no user guidelines.

console(config-if-1/g1)#storm-control multicast level 

5

Use the storm-control unicast command in Interface Configuration mode to 

enable unknown unicast storm control for an interface. If the mode is 

enabled, unicast storm recovery is active, and if the rate of unknown L2 

unicast (destination lookup failure) traffic ingressing on an interface increases 

beyond the configured threshold, the traffic will be dropped. Therefore, the 

rate of unknown unicast traffic will be limited to the configured threshold.
When you use the no storm-control multicast command to "disable" storm-

control after having set the level or rate to a non-default value, that value is 

still set but is not active until you re-enable storm-control.

rate]

• level— The configured rate as a percentage of link-speed.
•

rate — The configured rate in kilobits per second (kbps). (Range: 0-100)

The default value is 5.

Interface Configuration (Ethernet) mode