DELL PC6224F User Manual

IGMP Snooping Commands

The leave timeout should be set greater than the maximum time that a host 

is allowed to respond to an IGMP Query.
Use immediate leave only where there is only one host connected to a port. 

The following example configures the host leave-time-out to 60 seconds.

console(config-if-1/g1)#ip igmp snooping leave-time-

out 60

Use the ip igmp snooping mrouter-time-out command in Interface 

Configuration mode to configure the mrouter-time-out. This command is 

used for setting the aging-out time after Multicast router ports are 

automatically learned. To reset to the default mrouter-time-out, use the no 

form of this command.

ip igmp snooping mrouter-time-out 

time-out

•

time-out — mrouter timeout in seconds for IGMP. (Range: 1–3600)

The default value is 300 seconds.

Interface Configuration (Ethernet, port-channel) mode

This command has no user guidelines.