DELL 6024 User Manual
132
Configuring System Information
www
.dell.com | support.dell.com
Configuring Out-of-Band RADIUS Servers
The OOB RADIUS Settings page contains both user-defined and the default RADIUS settings for
the Out-of-Band management port. For more information on RADIUS servers, see "Configuring
TACACS+ Settings."
To open the OOB RADIUS Settings page, click System
the Out-of-Band management port. For more information on RADIUS servers, see "Configuring
TACACS+ Settings."
To open the OOB RADIUS Settings page, click System
→ Out-of-Band Port→ RADIUS in the tree
Figure 6-19.
OOB RADIUS Settings
IP Address—The Authentication Out-of-Band port IP address.
Priority (0-65535)—The Out-of-Band port priority. The possible values are 0-65535.
Authentication Port—The authentication port, which is used to verify the RADIUS server
authentication.
Number of Retries (1-10)—Number of transmitted requests sent to the RADIUS server before a
failure occurs. The possible field values are 1-10. The default value is 3. If no host-specific value is
specified, the global value applies to each host.
Timeout for Reply (1-30)—Amount of time in seconds the device waits for an answer from the
RADIUS server before timing out. The possible field values are 1-30. The default value is 3. If no
host-specific value is specified, the global value applies to each host.
Dead Time (0-2000)—Amount of time (in minutes) that a RADIUS server is bypassed for service
requests. The range is 0-2000. If no host-specific value is specified, the global value applies to each
host.
Priority (0-65535)—The Out-of-Band port priority. The possible values are 0-65535.
Authentication Port—The authentication port, which is used to verify the RADIUS server
authentication.
Number of Retries (1-10)—Number of transmitted requests sent to the RADIUS server before a
failure occurs. The possible field values are 1-10. The default value is 3. If no host-specific value is
specified, the global value applies to each host.
Timeout for Reply (1-30)—Amount of time in seconds the device waits for an answer from the
RADIUS server before timing out. The possible field values are 1-30. The default value is 3. If no
host-specific value is specified, the global value applies to each host.
Dead Time (0-2000)—Amount of time (in minutes) that a RADIUS server is bypassed for service
requests. The range is 0-2000. If no host-specific value is specified, the global value applies to each
host.