DELL 9.8(0.0) User Manual

ipv6 neighbor

Configure a static entry in the IPv6 neighbor discovery.

S4820T

Syntax

ipv6 neighbor [vrf vrf-name] {ipv6-address} {interface 
interface} {hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 
neighbor [vrf vrf-name] {ipv6-address} {interface interface} 
command.

Parameters

vrf vrf-name

(Optional) Enter the keyword vrf followed by the name of the 
VRF to install IPv6 routes in that VRF.

Enter the IPv6 address of the neighbor in the x:x:x:x::x 
format.

NOTE: The :: notation specifies successive hexadecimal 
fields of zero.

interface 
interface

Enter the keyword interface then the interface type and 
slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword 

TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword 

fortyGigE then the slot/port information.

• For a Loopback interface, enter the keyword loopback 

then a number from 0 to 16383.

• For a port channel interface, enter the keywords port-

channel then a number.

• For a Null interface, enter the keyword null then the Null 

interface number.

• For a VLAN interface, enter the keyword vlan then a 

number from 1 to 4094.

• For a tunnel interface, enter the keyword tunnel then 

the tunnel interface number. The range is from 1 to 

16383.

Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn 
format.

Defaults

none

Command 
Modes

CONFIGURATION

Command 
History

This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.

1224

Neighbor Discovery Protocol (NDP)