DELL 9.8(0.0) User Manual
enable inverse-mask
By default, Dell Networking Operating System (OS) allows you to input the OSPF network command
with a net-mask. This command provides a choice between inverse-mask or net-mask (the default).
S4820T
Syntax
enable inverse mask
To return to the default net-mask, use the no enable inverse mask command.
To return to the default net-mask, use the no enable inverse mask command.
Defaults
net-mask
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.1
Introduced on the S4810.
7.5.1.0
Introduced on the C-Series.
pre- 6.1.1.1
Introduced on the E-Series.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
S4820T
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
To cancel fast-convergence, use the no fast convergence command.
Parameters
number
Enter the convergence level desired. The higher this
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
1278
Open Shortest Path First (OSPFv2 and OSPFv3)