DELL 9.8(0.0) User Manual

{destination mask | any | host ip-address} [operator] 

command.

Parameters

redirect

Enter the keyword redirect to assign the sequence to the 
redirect list.

Enter the IP address of the forwarding router.

Enter the keyword slot / port followed by the slot/port 
information.

Enter the keyword tunnel to configure the tunnel setting.

Enter the keyword tunnel-id to redirect the traffic.

Enter the keyword track to enable the tracking.

Enter the keyword track <obj-id> to track object-id.

Enter a number from 0 to 255 for the protocol identified in 
the IP protocol header.

Enter one of the following keywords as the protocol type:

• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol

(OPTIONAL) For the TCP protocol type only, enter one or a 
combination of the following TCP flags:

• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field

Enter the IP address of the network or host from which the 
packets were sent.

Enter a network mask in /prefix format (/x).

any

Enter the keyword any to specify that all traffic is subject to 
the filter.

host ip-address

Enter the keyword host then the IP address to specify a host 
IP address.

Enter the IP address of the network or host to which the 
packets are sent.

(OPTIONAL) For TCP and UDP parameters only. Enter one of 
the following logical operand:

Policy-based Routing (PBR)

1385