DELL 9.8(0.0) User Manual
• urg = urgent field
operator
(OPTIONAL) For TCP and UDP parameters only. Enter one of
the following logical operand:
the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the portcommand parameter.)
Defaults
none
Command
Modes
Modes
REDIRECT-LIST
Command
History
History
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.4(0.0)
Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1
Introduced on the C-Series and S-Series.
8.4.2.0
Introduced on the E-Series Tera Scale.
7.7.1.0
Introduced on the E-Series ExaScale.
redirect
Configure a rule for the redirect list.
S4820T
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track
<obj-id>] {ip-protocol-number | protocol-type [bit]} {source
mask | any | host ip-address} {destination mask | any | host
ip-address} [operator]
To remove this filter, use one of the following:
<obj-id>] {ip-protocol-number | protocol-type [bit]} {source
mask | any | host ip-address} {destination mask | any | host
ip-address} [operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• You can also use the no redirect {ip-address | slot/port}| tunnel
tunnel-id}[track <obj-id>] {ip-protocol-number [bit] |
protocol-type} {source mask | any | host ip-address}
1384
Policy-based Routing (PBR)