DELL 9.8(0.0) User Manual

Usage 
Information

Dell Networking OS supports up to 16 SNMP trap receivers.

For the cam-utilization notification option, the system generates syslogs and 
SNMP traps when the L3 host table or route table utilization goes above the 
threshold.

If you do not configure this command, traps that controlled by this command are 
not sent. If you do not specify a notification-type and notification-
option, all traps are enabled.

Related 
Commands

snmp-server engineID

Configure the name for both the local and remote SNMP engines on the router.

Syntax

snmp-server engineID [local engineID] [remote ip-address vrf 
vrf-name udp-port port-number engineID]
To return to the default, use the no snmp-server engineID [local 
engineID] [remote ip-address vrf vrf-name udp-port port-number 
engineID] command.

Parameters

local engineID

Enter the keyword local followed by the engine ID number 
that identifies the copy of the SNMP on the local device.

Format (as specified in RFC 3411): 12 octets.

• The first four octets are set to the private enterprise 

number.

• The remaining eight octets are the MAC address of the 

chassis.

remote ip-
address

Enter the keyword remote followed by the IP address that 
identifies the copy of the SNMP on the remote device.

vrf vrf-name

Enter the keyword vrf followed by the name of the VRF that 
is used to reach the device.

NOTE: Use this attribute to specify the VRF that is used 
by the SNMP engine to reach the device. If no VRF is 
specified, then the default VRF is used.

udp-port port-
number 
engineID

Enter the keywords udp-port followed by the user 
datagram protocol (UDP) port number on the remote device. 
The range is from 0 to 65535. The default is 162.

Defaults

As above.

1702

Simple Network Management Protocol (SNMP) and Syslog