DELL 9.8(0.0) User Manual
Version
Description
6.2.1.1
Introduced on the E-Series.
Usage
Information
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the
software only sends information on BPDUs for the last interface specified.
software only sends information on BPDUs for the last interface specified.
Related
Commands
Commands
— enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description
Enter a description to identify the spanning tree (80
characters maximum).
characters maximum).
Defaults
none
Command
Modes
Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced
Related
Commands
Commands
— enters SPANNING TREE mode on the switch.
1772
Spanning Tree Protocol (STP)