DELL 9.8(0.0) User Manual
disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
To enable Spanning Tree Protocol, use the no disable command.
Defaults
Enabled (that is, the spanning tree protocol is disabled.)
Command
Modes
Modes
SPANNING TREE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Related
Commands
Commands
— enters SPANNING TREE mode on the switch.
forward-delay
The amount of time the interface waits in the Listening state and the Learning state before transitioning
to the Forwarding state.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
To return to the default setting, use the no forward-delay command.
Parameters
seconds
Enter the number of seconds the Dell Networking OS waits
before transitioning STP to the Forwarding state. The range is
from 4 to 30. The default is 15 seconds.
before transitioning STP to the Forwarding state. The range is
from 4 to 30. The default is 15 seconds.
Spanning Tree Protocol (STP)
1773