DELL 9.8(0.0) User Manual
peer-routing-timeout
Configure the delay after which peer routing is disabled when the peer is unavailable. This command is
applicable for both IPV6/IPV4. If not configured, peer-routing will not be disabled at all even though the
peer is unavailable.
applicable for both IPV6/IPV4. If not configured, peer-routing will not be disabled at all even though the
peer is unavailable.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
To restore the default value, use the no peer-routing-timeout command.
Parameters
value
Enter the timeout value in seconds. The range is from 1 to
65535. The default value is infinity.
65535. The default value is infinity.
Command
Modes
Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.7(0.0)
Added support for default value on the S-Series and Z-
Series.
Series.
9.5(0.1)
Introduced on the Z9500.
9.4(0.0)
Added the support for IPV6 / IPV4.
9.2(0.2)
Introduced on the Z9000, S4810, and S4820T.
9.0.2.0
Introduced on the S6000.
Usage
Information
Information
When the timer expires, the software checks to see if the VLT peer is now available.
If the VLT peer is not available, peer-routing is disabled on that peer.
If the VLT peer is not available, peer-routing is disabled on that peer.
primary-priority
Assign the priority for master election among VLT peers.
Syntax
[no] primary-priority
Parameters
value
To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
value than the priority value of the remote peer. The range is
from 1 to 65535.
1850
Virtual Link Trunking (VLT)