DELL 9.8(0.0) User Manual
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
Usage
Information
Information
At least one interface must be in Layer 3 mode for the router bgp command to
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a configured AS number.
Example
Dell(conf)#router bgp 3
Dell(conf-router_bgp)#
set extcommunity bandwidth
Enables you to set extended community bandwidth.
Syntax
set extcommunity bandwidth
To disable extended community bandwidth, enter the no set extcommunity
bandwidth command.
To disable extended community bandwidth, enter the no set extcommunity
bandwidth command.
Parameters
bandwidth
Enter the keyword bandwidth to enable extended
community bandwidth. The range is from 0 to 102400.
community bandwidth. The range is from 0 to 102400.
Defaults
N/A
Command
Modes
Modes
ROUTER MAP
Command
History
History
Version
Description
9.7(0.0)
Introduced on the S-Series.
Border Gateway Protocol
481