DELL 9.8(0.0) User Manual

You can only associate output QoS policy profiles with the priority groups in the 
DCB output profile context; output QoS policy profiles are not permitted on output 
policy-maps.

WRED, ECN, rate shaping, and rate limiting are not supported in output policies 
because DCBx does not negotiate these parameters with peer devices. You can 
apply a QoS output policy with WRED and/or rate shaping on a DCBx CIN-enabled 
interface.

If you enable the scheduler command for a QoS ETS output policy, no 
bandwidth percentage is assigned to the policy.

Related 
Commands

•

•

in port queues.

set-pgid

Configure the priority-group identifier.

Syntax

set-pgid value
To remove the priority group, use the no set-pgid command.

Parameters

Enter the priority group identification. The range is from 0 to 
7.

Defaults

none

Command 
Modes

PRIORITY-GROUP

Command 
History

This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

and S4048–

Version

Description

8.3.19.0

Introduced on the S4820T.

8.3.12.0

Introduced on the S4810.

8.3.16.0

Introduced on the MXL 10/40GbE Switch IO Module.

Usage 
Information

NOTE: Please note that Dell Networking does not recommended to use this 
command as it has been deprecated in the current 9.4.(0.0) release. A warning 
message appears when you try to run this command indicating that you have 
to use the dcb-map commands in the future.

576

Data Center Bridging (DCB)