DELL 9.8(0.0) User Manual
interface ManagementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
S4820T
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port
Enter the keyword ManagementEthernet, then the slot
number (0 or 1) and port number zero (0).
number (0 or 1) and port number zero (0).
Defaults
Not configured.
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.11.1
Introduced on the S55, S60, and S4810.
8.1.1.0
Introduced on the E-Series ExaScale.
7.5.1.0
Introduced on the C-Series.
6.4.1.0
Introduced
Usage
Information
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
address to the Management port, use the ip address command.
If your system has two RPMs installed, use the show redundancy command to
display which RPM is the Primary RPM.
display which RPM is the Primary RPM.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
Related
Commands
Commands
interface or a forwarding router.
Interfaces
803