National Instruments NI CVS-1450 Series User Manual
Chapter 2
Setup and Configuration
2-16
ni.com
Installing the LabVIEW Real-Time Module, Vision Development
Module, and NI-IMAQ for IEEE 1394 Cameras
Module, and NI-IMAQ for IEEE 1394 Cameras
Note
You must install LabVIEW, the LabVIEW Real-Time Module, and the Vision
Development Module software before installing the NI-IMAQ for IEEE 1394 Cameras
driver software.
driver software.
Complete the following steps to install LabVIEW, the LabVIEW
Real-Time Module, the Vision Development Module, and NI-IMAQ for
IEEE 1394 Cameras onto the development computer.
Real-Time Module, the Vision Development Module, and NI-IMAQ for
IEEE 1394 Cameras onto the development computer.
1.
Insert the LabVIEW CD into the CD-ROM drive.
2.
When the installation splash screen appears, click Install LabVIEW,
and follow the setup instructions.
and follow the setup instructions.
3.
Insert the LabVIEW Real-Time Module CD into the CD-ROM drive.
4.
When the installation splash screen appears, click Install LabVIEW
Real-Time Module, and follow the setup instructions.
Real-Time Module, and follow the setup instructions.
5.
Insert the Vision Development Module CD into the CD-ROM drive.
6.
When the splash screen appears, click Install Vision Development
Module, and follow the setup instructions.
Module, and follow the setup instructions.
7.
Insert the NI-IMAQ for IEEE 1394 Cameras CD into the CD-ROM
drive.
drive.
Note
If you select the custom software installation, make sure to install the support for the
CVS-1450 Series.
8.
When the splash screen appears, click Install NI-IMAQ for
IEEE 1394 Cameras, and follow the setup instructions.
IEEE 1394 Cameras, and follow the setup instructions.
9.
When prompted, click Yes to restart the development computer.
Configuring the IP Address using the LabVIEW Real-Time Module
To set up an IP address for the CVS-1450 device, complete the following
steps:
steps:
1.
Open the Measurement & Automation Explorer (MAX) configuration
software by double-clicking the MAX icon on the desktop, or navigate
to MAX by selecting Start»Programs»National Instruments»
Measurement & Automation.
software by double-clicking the MAX icon on the desktop, or navigate
to MAX by selecting Start»Programs»National Instruments»
Measurement & Automation.
2.
Expand the Remote Systems branch of the configuration tree, and
click 192.168.10.12 to display the Network Settings window.
This IP address is assigned to all unconfigured CVS-1450 devices.
click 192.168.10.12 to display the Network Settings window.
This IP address is assigned to all unconfigured CVS-1450 devices.