Fujitsu eLux NG S26361-F2600-L134 User Manual
Product codes
S26361-F2600-L134
www.
myelux
.com
eLux
®
NG
Build # 27
44
3.6.2.2 Activating USB port
For security reasons, by default the USB port is deactivated. From the Hardware tab, click to
activate the USB mass storage devices check box. Note that update over floppy is not
supported.
activate the USB mass storage devices check box. Note that update over floppy is not
supported.
3.6.3 Starting an update
1.
From the Setup tab, click the Firmware subtab.
2.
Select the Click for update on boot check box to check for an update when the Thin
Client boots.
Client boots.
3. Select
the
Update confirmation necessary
check box for a confirmation message to
appear before an update takes place. If you click on Details in this confirmation box,
the packages that will be installed/removed are displayed.
the packages that will be installed/removed are displayed.
4. Click
Apply
to save your changes.
5. Click
Update
to perform a recovery immediately.
During an update, eLux NG compares the software on the Thin Client to the software in the
image definition file. If they differ, an update is performed. (The name of the IDF is irrelevant,
because it is the contents that are examined.)
Warning
Never switch off the Thin Client during an update procedure! This can destroy the
image and the terminal will no longer boot. In this case, contact your system administrator and
perform a recovery (see chapter “6 Recovery Installation”).
perform a recovery (see chapter “6 Recovery Installation”).
The following two sections describe buttons that are in the Firmware tab, but do not directly
relate to a firmware update.
If the update cannot be performed, the reason is displayed in a dialog. In addition, you can
click on Details to display the technical details.
relate to a firmware update.
If the update cannot be performed, the reason is displayed in a dialog. In addition, you can
click on Details to display the technical details.