Fujitsu eLux NG S26361-F2600-L134 用户手册

 

 

 

 

 

 

Build # 27

  

44

 

For security reasons, by default the USB port is deactivated. From the Hardware tab, click to 
activate the USB mass storage devices check box. Note that update over floppy is not 
supported. 

1. 

From the Setup tab, click the Firmware subtab.

 

2. 

Select the Click for update on boot check box to check for an update when the Thin 
Client boots.

 

3. Select 

the 

 check box for a confirmation message to 

appear before an update takes place. If you click on Details in this confirmation box, 
the packages that will be installed/removed are displayed. 

4. Click 

 to save your changes. 

5. Click 

 to perform a recovery immediately.  

 
During an update, eLux NG compares the software on the Thin Client to the software in the 
image definition file. If they differ, an update is performed. (The name of the IDF is irrelevant, 
because it is the contents that are examined.)  

 

Never switch off the Thin Client during an update procedure! This can destroy the 

image and the terminal will no longer boot. In this case, contact your system administrator and 
perform a recovery (see chapter “6 Recovery Installation”). 

 

The following two sections describe buttons that are in the Firmware tab, but do not directly 
relate to a firmware update.  
If the update cannot be performed, the reason is displayed in a dialog. In addition, you can 
click on Details to display the technical details.