3com 9000 SX User Manual

To display the SNMP settings configured on the Switch 9000, use the 
following command:

show management

This command displays the following information:

■

Enable/disable state for telnet, SNMP, and web access

■

SNMP community strings

Table 3-4   SNMP Configuration Commands 

config vlan <name> ipaddress <ip_address> {<mask>}

Configures an IP address for the VLAN. This is 
required in order to use an SNMP manager.

enable snmp access

Allows you to turn on SNMP support for the 
Switch.

enable snmp trap

Allows you to turn on SNMP trap support.

config snmp add <ipaddress>

Allows you to add the IP address of an SNMP 
management station to the access list. Up to six 
address can be specified.

config snmp add trapreceiver <ipaddress> {<string>}

Allows you to add the IP address of a specified 
trap receiver. A maximum of six trap receivers is 
allowed.

config snmp community [read | readwrite] <string>

Allows you to configure the SNMP read and 
write community strings. The community string 
can have a maximum of 32 characters. 

config snmp delete [<ipaddress> | all]

Allows you to delete the IP address of a specified 
SNMP management station or all SNMP 
management stations.

config snmp delete trapreceiver [<ip_address> | all]

Allows you to delete the IP address of a specified 
trap receiver or all authorized trap receivers. If 
you delete all trap receiver addresses, any 
machine can have SNMP management access to 
the Switch.

config snmp syscontact <string>

Allows you to configure the name of the system 
contact. A maximum of 32 characters is allowed.

config snmp sysname <string>

Allows you to configure the name of the 
Switch. The sysname appears in the command 
line interface prompt. A maximum of 32 
characters is allowed. The default sysname is 

3C16990

.

config snmp syslocation <string>

Allows you to configure the location of the 
Switch. A maximum of 32 characters is allowed.

SW9000.BK  Page 11  Wednesday, April 1, 1998  11:00 AM