3com WX3000 User Manual
2-2
QoS Profile Configuration
QoS Profile Configuration Task List
Complete the following tasks to configure a QoS profile:
Task
Remarks
Required
Optional
Optional
Configuring a QoS Profile
Configuration prerequisites
z
The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
z
The type and number of actions in the QoS profile are specified.
Configuration procedure
Follow these steps to configure a QoS profile:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a QoS profile and
enter QoS profile view
enter QoS profile view
qos-profile profile-name
—
Configure traffic policing
traffic-limit inbound acl-rule
target-rate [ conform con-action ]
[ exceed exceed-action ]
[ meter-statistic ]
target-rate [ conform con-action ]
[ exceed exceed-action ]
[ meter-statistic ]
Optional
Configure packet filtering
packet-filter inbound acl-rule
Optional
Refer to the ACL module of
this manual for information
about packet filtering.
this manual for information
about packet filtering.
Configure priority marking
traffic-priority inbound acl-rule
{ dscp dscp-value | cos cos-value }
{ dscp dscp-value | cos cos-value }
Optional
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile manually.
Configuration prerequisites
z
To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both globally and on
the port, and the authentication mode is determined. For information about 802.1x, refer to the
802.1x and System Guard module of this manual.
z
To apply a QoS profile manually, make sure the port to which the QoS profile is to be applied is
determined.
z
The QoS profile to be applied is determined.