3com 3CRWX120695A WXR100 User Manual

C

HAPTER

 6: C

ONFIGURING

 WX S

YSTEM

 P

ARAMETERS

To use an existing rule, leave the rule in the list.

c Click Next.

d Select the authentication and accounting method (RADUS server 

group or local database). 

(For information, see “AAA Methods (RADIUS Server Groups and the 
Local User Database)” on page 240.) 

e Click Next.

To configure accounting, select Enabled, select the record type 
(Start-Stop or Stop-Only), then select LOCAL or a RADIUS server group 
for the accounting and click Add.

g Click Finish.

„

If you selected None in step 2, you are finished with this 
procedure.

„

If you selected Web Portal in step 2, go to step 7.

„

If you selected Open Access in step 2, go to step 11.

7 If you selected Web Portal in step 2, select the VLAN to which you want 

the switch to assign Web Portal users. Otherwise, go to step 11.

8 Click Next.

The ACEs (ACL rules) that 3WXM will configure for the Web-Portal 
service are listed. The ACEs are required to allow DHCP traffic while 
blocking all other traffic while a user is being authenticated. These ACEs 
are used only during authentication. After the user is authenticated, the 
ACEs are not used. 

If you need to add ACEs, continue with this step. Otherwise, go to step 9. 

„

To add an ACE, click Add Rule. 3WXM adds an ACE to the end of the 
list. The ACE matches on all source and destination IP addresses and 
denies them. 

„

To modify an ACE, select the part of the ACE you want to modify, and 
edit or select the new value. (For information about ACE settings, see 
“Viewing and Configuring ACLs” on page 220.) 

9 Click Next.