3com WX1200 User Manual
412
C
HAPTER
12: STP C
OMMANDS
See Also
set spantree
fwddelay
fwddelay
Changes the period of time after a topology change that a WX switch
which is not the root bridge waits to begin forwarding Layer 2 traffic on
one or all of its configured VLANs. (The root bridge always forwards
traffic.)
which is not the root bridge waits to begin forwarding Layer 2 traffic on
one or all of its configured VLANs. (The root bridge always forwards
traffic.)
Syntax —
set spantree fwddelay delay {all | vlan vlan-id}
delay
— Delay value. You can specify from 4 through 30 seconds.
all
— Changes the forwarding delay on all VLANs.
vlan
vlan-id
— VLAN name or number. MSS changes the
forwarding delay on only the specified VLAN.
Defaults — The default forwarding delay is 15 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the forwarding delay on
VLAN pink to 20 seconds:
VLAN pink to 20 seconds:
WX4400# set spantree fwddelay 20 vlan pink
success: change accepted.
success: change accepted.
See Also
set spantree hello
Changes the interval between STP hello messages sent by a wireless LAN
switch when operating as the root bridge, on one or all of its configured
VLANs.
switch when operating as the root bridge, on one or all of its configured
VLANs.
Syntax —
set spantree hello interval {all | vlan vlan-id}
interval
— Interval value. You can specify from 1 through 10
seconds.
all
— Changes the interval on all VLANs.