3com WX1200 User Manual
414
C
HAPTER
12: STP C
OMMANDS
Examples — The following command changes the maximum acceptable
age for root bridge hello packets on all VLANs to 15 seconds:
age for root bridge hello packets on all VLANs to 15 seconds:
WX4400# set spantree maxage 15 all
success: change accepted.
success: change accepted.
See Also
set spantree
portcost
portcost
Changes the cost that transmission through a network port or ports in
the default VLAN on a wireless LAN switch adds to the total cost of a
path to the STP root bridge.
the default VLAN on a wireless LAN switch adds to the total cost of a
path to the STP root bridge.
Syntax —
set spantree portcost port-list cost cost
port-list
— List of ports. MSS applies the cost change to all the
specified ports.
cost
cost
— Numeric value. You can specify a value from 1 through
65,535. STP selects lower-cost paths over higher-cost paths.
Defaults — The default port cost depends on the port speed and link
type. Table 73 lists the defaults for STP port path cost.
type. Table 73 lists the defaults for STP port path cost.
Table 73 SNMP Port Path Cost Defaults
Port Speed
Link Type
Default Port Path Cost
1000 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
1000 Mbps
Full Duplex
4
100 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
100 Mbps
Full Duplex
18
100 Mbps
Half Duplex
19
10 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
10 Mbps
Full Duplex
95
10 Mbps
Half Duplex
100