3com 4500 PWR 50-PORT User Manual
166
C
HAPTER
6: U
SING
R
OUTING
P
ROTOCOL
C
OMMANDS
IP Routing Policy
Configuration
Commands
Configuration
Commands
This section describes the commands you can use to configure IP Routing Policy.
These commands operate across all routing protocols.
These commands operate across all routing protocols.
When the Switch 4500 runs a routing protocol, it is able to perform the functions
of a router. The term router in this section can refer either to a physical router or to
the Switch 4500 running a routing protocol.
of a router. The term router in this section can refer either to a physical router or to
the Switch 4500 running a routing protocol.
apply cost
Syntax
apply cost value
undo apply cost
View
Route Policy View
Parameter
value
Enter the route cost value of route information.
Description
Use the
apply cost
command to configure the route cost value of route
information. This command is one of the
apply
sub-statements of the
Route-policy attribute set.
Use the
undo apply cost
command to cancel the apply sub-statement.
Related commands:
if-match interface
,
if-match acl
,
if-match ip-prefix
,
if-match ip next-hop
,
if-match cost
, and
route-policy
.
Example
Define one
apply
sub-statement. When it is used for setting route information
attribute, it sets the route metric value of route information to 120.
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]route-policy permit node 1
% New sequence of this list
[4500-route-policy]apply cost 120
display ip ip-prefix
Syntax
display ip ip-prefix [
ip_prefix_name ]
View
All views
Parameter
ip_prefix_name
Enter displayed address prefix list name.
Description
Use the
display ip ip-prefix
command to view the address prefix list.
Related command:
ip ip-prefix
.