Panasonic 1200N User Manual

4.

Delete the SVC signaling PVC connection.

This command deletes the PVC connection signaling VCI for the specified 
port.  The default VPI/VCI is 0/5.

Example:  

Because of intelligent traffic being sent between ATM switches, sometimes the port
configures itself with a PNNI signaling channel.  If the interface needs to be
modified, this PVC connection will also need to be deleted.   The default PNNI VPI/
VCI is 0/18.

5.

Delete the PNNI signaling PVC connection.

Example:  

At this time you are able to modify the interface port.

6.

Configure the interface.

Example: 

This command opens a configuration sub-routine. The parameters already
identified in Step 1 will be prompted on an individual basis.  Remember that the
VPI and VCI bit field entries DO NOT identify the VPI/VCI that you will be using
for the port. These two fields identify the number of bits that will be used for each
field.  The defaults are 6 and 8 for VPI and VCI, respectively.  

With the interface properly configured, ILMI signaling and PNNI should be
restored (as needed).

7.

Install the ILMI and SVC signaling connections.

Example:  

Default=0
VPI/VCI ilmi default=0/16

Example:  

Default=0
VPI/VCI signaling default=0/5

8.

Sometimes the signaling parameters are incorrect for the port that you are 
configuring.  Use the following command to check the parameters:

This command displays all of the ports and their signaling parameters.