Panasonic 1200N User Manual
Basic Configuration and Setup
Ongoing Configuration
Centillion 1200N ATM Switch User Manual
8-7
NTP 297-8103-903
9.
Use the
SET ATMSIG
command to change the parameters of the signaling.
SET atmsig [slot number][port number] [vpi number]
This command will enter a configuration sub-routine which will prompt you
for 12 different parameters, including the UNI version (3.0, 3.1 or 4.0) and the
location of the port (logical network side or user side). It is not recommended
that the timer values be changed unless the user is fully aware of the
consequences.
for 12 different parameters, including the UNI version (3.0, 3.1 or 4.0) and the
location of the port (logical network side or user side). It is not recommended
that the timer values be changed unless the user is fully aware of the
consequences.
10.
Once configured, the SVC signaling must be returned to normal operation.
SET svcline [slot number][port number] [vpi number]
resume
If all is configured properly, the port should be ready to respond to SVC requests.
Continue with the next section which describes how to set up the PVCs.
Continue with the next section which describes how to set up the PVCs.
11.
Install the PNNI signaling VCI. (This step is only required if the interface will
be a NNI port.)
be a NNI port.)
SET pnni [slot number][port number] [vpi number]
Example:
SET pnni 23
Default=0