Sony MKS-2010 User Manual

Cha

p

te

r 5

 Ba

si

c Op

er

a

tio

ns

61

Selecting Effects

When you add a shadow or trail to an effect applied to a key and then execute 

the transition, the shadow or trail disappears instantly as soon as the 
transition ends.

Non-transition effects (picture-in-picture, etc.): A bus and B bus cross-points 

are not switched, even after the effect ends. Also, when border, cropping, or 
other modifications

 1)

 have been added, they do not disappear, even after the 

transition ends.  

1) Modifications listed in “Effect Pattern Transformations and Modifications” in the Appendix 

(separate document).

When an effect pattern numbered 2001 or higher is selected, you need to select 
the operating channels.

Press the [M/E 1CH] or [M/E 2CH] delegation selection button in the Effect/
Wipe control block, lighting the button. You can also select both channels.

Two channels cannot be selected at once from a menu.
However, when two channels are selected with the buttons in the Effect/Wipe 
control block, both of the buttons are lit in the menu.

From the top menu, select Effect/Wipe >M/E Effect >Main.

The Main menu appears.

Press [M/E 1ch] or [M/E 2ch] to select a channel. 

If two channels are selected with the delegation selection buttons in the 
effect/wipe control block of the control panel, the parameter setting values 
for the reference channel are shown in the menu. Settings for the two 
channels are adjusted with relative values.

Parameters which can be set individually for each channel
• Size and position of the effect pattern (Position), and border color of the effect 

pattern (Border Color)

• Brightness of beveled edges (Light mode), direction of light source (Light 

mode/Color mode), color (Color mode), softness of edges (Edge Soft)

• Adjustment of crop picture frame (Crop)