Hearth & Home Technologies WSK-MLT User Manual

3

Standing Pilot Ignition: 

Find these parts packed with WSK-MLT:

• Rocker switch

•  Rocker switch bracket

•  Strips of Velcro

•  Black and white wire pigtails - (2)

•  Female ends (only used on Standing Pilot 

applications) - (2)

Cut male ends off black wires on each pigtail. Strip each 
end of wire approximately 1/4 inch. Slide each stripped 
wire into a female end and crimp. Slide rocker switch into 
bracket until it snaps into place. Attach end of each pigtail 
to each side of rocker switch. Find the top (brown) and 
bottom (red) wires from the control box and attach to white 
wires from rocker switch. Attach one black wire to the TH/TP 
side of gas valve and the other to the TH side of the gas 
valve. Attach the Velcro to the bottom of the rocker switch 
bracket and mount in a convenient location next to gas 
valve. (Refer to Figure 4).

1.  Place control box into the base pan  area of the fi replace. 

Place unit as close to the louvers or decorative front as 
possible and to either the left or right side. 

2.  Connect the red, yellow or white, and green wires to the 

appropriate labeled terminals on the control box.

3.  Find the red and brown pigtail wire (labeled “ FOR USE 

WITH REMOTE OR WALL SWITCH ONLY”) which are 
attached to the fi replace ON/OFF rocker switch. 

Standing Pilot Ignition: Connect these wires with the 
red and brown wires extending from control box (Fig 2).

 

Intellifi re  (IPI):  Connect these wires with the brown 
wires extending from the control box (see Figure 3).

•  Do NOT install the control box when fi replace is hot.

•  Do NOT plug control box in until all connections are 

complete.

* May be labeled as “W” or “Y”.