Denon AVP-A1HD User Manual
Get
ting Star
ting Star
ted
Connections
Other Oper
ations
Multi-Zone
Inf
or
or
mation
Tr
oubleshooting
Specifications
Set
up
up
Examples
Error details
Measures
AUTO SETUP
1 2 3 4 5 6
RETURN
Skip
SW Level Matching
The subwoofer's level is too high or low. Please select "SW
Level Matching" and adjust the level of your subwoofer unit.
If you do not want to use the
subwoofer, select "Skip".
Proceed to subwoofer volume adjustment item
Enter
Cancel
Caution!
• Correct measurement is not possible due to inappropriate subwoofer
volume.
• When using a subwoofer with built-in amplifier (active type), use
“SW Level Matching” to adjust the subwoofer volume (
vpage 17
“Adjusting the subwoofer volume level”).
• When using a subwoofer without a built-in amplifier, select “Skip”,
and then press
ENTER
.
AUTO SETUP
RETURN
Retry
No microphone or speaker
Check cause of problem!
Cancel
Caution!
• The connected setup microphone is broken, or a device other than
the supplied setup microphone is connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• The front L speaker was not properly detected.
• Connect the included setup microphone to the SETUP MIC jack of
this unit.
• Check the speaker connections.
AUTO SETUP
RETURN
Retry
Ambient noise is too high
or Level is too low
Check cause of problem!
Cancel
Caution!
• There is too much noise in the room for accurate measurements to
be made.
• Speaker or subwoofer sound is too low for accurate measurements
to be made.
• Either turn off any device generating noise or move it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in which the speakers
are facing.
• Adjust the subwoofer’s volume.
AUTO SETUP
1 2 3 4 5 6
RETURN
Retry
Front R
None
Check cause of problem!
Cancel
Caution!
• The displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot
(The screen on the left indicates that the front right speaker cannot
be detected.)
• Check the connections of the displayed speaker.
AUTO SETUP
1 2 3 4 5 6
RETURN
Skip
Retry
Front R
Phase
Check cause of problem!
Cancel
Caution!
• The displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front
(The screen on the left indicates that the polarity phases of the front
right speakers are reversed.)
• Check the polarity of the displayed speaker.
• For some speakers, this error message may be displayed even if
• For some speakers, this error message may be displayed even if
the speaker is properly connected. If you are sure the connection is
correct, press
correct, press
ui
to select “Skip”, then press
ENTER
.
Error messages
NOTE
• An error message is displayed if Auto Setup could not be completed due to speaker placement, the measurement environment, etc. Check the related items, and implement the necessary measures. After resolving
the error, perform Auto Setup again.
• If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
• Be sure to turn off the power before checking speaker connections.