ZyXEL Communications XGS-4526 User Manual
Chapter 42 VRRP
XGS-4526/4528F/4728F User’s Guide
376
42.3.3 Configuring VRRP Parameters
After you set up an IP interface, configure the VRRP parameters in the VRRP
Configuration screen.
Configuration screen.
Figure 196 IP Application > VRRP Configuration > VRRP Parameters
The following table describes the labels in this screen.
Table 137 IP Application > VRRP Configuration > VRRP Parameters
LABEL
DESCRIPTION
Active
Select this option to enable this VRRP entry.
Name
Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
identification purposes.
Network
Select an IP domain to which this VRRP entry applies.
Virtual Router ID
Select a virtual router number (1 to 7) for which this VRRP entry is
created.
created.
You can configure up to seven virtual routers for one network.
Advertisement
Interval
Interval
Specify the number of seconds between Hello message
transmissions. The default is 1.
transmissions. The default is 1.
Preempt Mode
Select this option to activate preempt mode.
Priority
Enter a number (between 1 and 254) to set the priority level. The
bigger the number, the higher the priority.
bigger the number, the higher the priority.
This field is 100 by default.
Uplink Gateway
Enter the IP address of the uplink gateway in dotted decimal
notation.
notation.
The Switch checks the link to the uplink gateway.
Primary Virtual IP
Enter the IP address of the primary virtual router in dotted decimal
notation.
notation.
Secondary Virtual
IP
IP
This field is optional. Enter the IP address of a secondary virtual
router in dotted decimal notation. This field is ignored when you
enter 0.0.0.0.
router in dotted decimal notation. This field is ignored when you
enter 0.0.0.0.