ZyXEL Communications XGS-4526 User Manual

 Chapter 42 VRRP

XGS-4526/4528F/4728F User’s Guide

View the VRRP configuration summary at the bottom of the screen. 

Figure 197   VRRP Configuration: Summary 

The following table describes the labels in this screen. 

The following sections show two VRRP configuration examples on the Switch. 

Add

Click Add to save your changes to the Switch’s run-time memory. 
The Switch loses these changes if it is turned off or loses power, so 
use the Save link on the top navigation panel to save your changes 
to the non-volatile memory when you are done configuring.

Cancel Click 

Cancel to discard all changes made in this table.

Clear

Click Clear to set the above fields back to the factory defaults. 

Table 137   IP Application > VRRP Configuration > VRRP Parameters  (continued)

Table 138   VRRP Configuring: VRRP Parameters 

Index

This field displays the index number of an entry. 

Active

This field shows whether a VRRP entry is enabled (Yes) or disabled (No). 

Name

This field displays a descriptive name of an entry. 

Network

This field displays the IP address and subnet mask of an interface. 

VRID

This field displays the ID number of a virtual router. 

Primary VIP

This field displays the IP address of the primary virtual router.

Uplink 
Gateway

This field displays the IP address of the uplink gateway.

Priority

This field displays the priority level (1 to 255) of the entry. 

Delete

Click Delete to remove the selected entry from the summary table.

Cancel

Click Cancel to clear the Delete check boxes.