Allied Telesis AT-9000/52 User Manual

Chapter 18: Setting LLDP and LLDP-MED

232

To display the LLDP Civic, Coordinate, and ELIN locations, use the 
following procedures:











For information about configuring LLDP and LLDP-MED, see “Configuring 
LLDP and LLDP-MED” on page 210

To display the basic LLDP configuration, do the following:

1. Select the Discovery & Monitoring tab.

The Discovery & Monitoring tab is displayed. See Figure 68 on page 
201.

2. From the Discovery & Monitoring tab, select LLDP.

The LLDP tab appears to the right.

3. From the LLDP tab, select the Basic Configuration tab.

The LLDP Configuration page is displayed. See Figure 76 on page 
211.

The following fields are displayed:



Status— Indicates whether LLDP is enabled or disabled on the 
switch. By default, LLDP is disabled on the switch.



Timer— Specifies the transmit interval. The range is 5 to 32,768 
seconds.



Fast Start Count— Indicates the fast start count for LLDP-MED. 
The fast start count determines how many fast start 
advertisements LLDP sends from a port when it begins sending 
LLDP-MED advertisements from a port, for instance when it 
detects a new LLDP-MED capable device. The default value is 3.



Holdtime Multiplier— Sets the holdtime multiplier value. The 
transmit interval is multiplied by the holdtime multiplier to give the 
Time To Live (TTL) the switch advertises to the neighbors. The 
range is 2 to 10.



Non Strict Med TLV Order Check— Sets the switch to accept 
LLDP-MED advertisements even if the TLVs are not in the