Allied Telesis AT-9000/52 User Manual
Chapter 3: Basic Switch Parameters
50
Rebooting a Switch
Resetting the switch ends your web browser management session. To
continue managing the switch, you must login again.
continue managing the switch, you must login again.
Note
All unsaved changes are discarded when you reset a switch. To
save your changes, click SAVE on the home page.
save your changes, click SAVE on the home page.
To reboot a switch, perform the following procedure:
1. Select the System Tab.
The System Settings Tab is displayed. See Figure 6 on page 33.
2. From the System Settings tab, select Dashboard.
The Dashboard Page is displayed. See Figure 4 on page 23.
3. Select Reboot at the bottom of the page.
A confirmation prompt is displayed that indicates that the connection to
the web is lost during a reboot.
the web is lost during a reboot.
4. Click OK to reset the switch or Cancel to cancel the procedure.
Note
The switch does not forward packets while it initializes the
AlliedWare Plus software and loads its active configuration file. This
process takes between 20 seconds to 2 minutes to complete,
depending on the number and types of commands in the
configuration file.
AlliedWare Plus software and loads its active configuration file. This
process takes between 20 seconds to 2 minutes to complete,
depending on the number and types of commands in the
configuration file.