Allied Telesis AT-PWR06 User Manual
Stack Installation Guide for AT-2552XS L2 Data Center Switch
59
7. Refer to Table 9 on page 56 for the recommended fiber optic cable.
Insert the cable to the port on the transceiver, as shown in Figure 28,
until it snaps in place.
until it snaps in place.
Figure 28. Attaching a Fiber Optic Cable to an SFP+ Transceiver
8. Repeat steps 6 and 7 for the cable installation into the remaining SFP+
transceivers that are installed.
Installing a SFP+
Direct Attach
Cables
The AT-SP10TW1, AT-SP10TW3 and AT-SP10TW7 10G direct attach
cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+
cable modules are ordered and supplied separately from the
AT-DC2552XS.
cables come in 1m, 3m, and 7m cable lengths respectively. These SFP+
cable modules are ordered and supplied separately from the
AT-DC2552XS.
Perform the following procedure to install a SFP+ direct attach cables:
1. Remove the dust plug from a SFP+ slot on the switch. Refer to Figure
Figure 29. Removing the Dust Plug from a SFP+ Slot