Allied Telesis fast ethernet 10/100 hubs User Manual

AT-FH812u and AT-FH824u User’s Guide

19

Select Port Security Control from the Port Configuration screen to configure port 
intrusion protection. The parameters are described in Figure 12 and Table 11.

-------------------------------------

Port Security Control (1 - 12)

Hub ID : 1
Port 

Mode

Auth. Address L.S. Address

Intrusion Action

1.  MANUAL

0000e8-123456 0000e8-123456

WARNING & DISABLE

2.  AUTO

0000e8-123798 0000e8-123798

WARNING & DISABLE

3. AUTO

0000e8-527456 0000e8-527456

INACTIVE

4.

000000-000000

5.

000000-000000

6.

000000-000000

7.

000000-000000

8.

000000-000000

9.

000000-000000

10.

000000-000000

11.

000000-000000

12.

000000-000000

<APPLY>

 <OK> 

 <CANCEL>

<PORT_13_24>

The authorized address assignment mode of the port.

Use TAB or Cursor keys to move. <Space> to select.

-------------------------------------

Figure 12  Port Security Control Parameters (from Port Configuration Screen)

Enabling a Port. To enable a port that has been disabled by an intrusion: 

(1.) Manually disable it in the Administration Status menu. 
(2.) Re-enable it again.

These two steps will restore the connection. (See Note on Configuring Port 
Parameters on page 16.)

Table 11  Definition of Port Security Control Parameters

Mode

AUTO - Copies authorized address from currently attached device.
MANUAL - Allows administrator to enter authorized address by hand.

Auth. Address

MAC address of device authorized to access this port.

LS. Address

MAC address of the last device attached to this port.

Intrusion Action

Any of the following actions can be selected if intrusion is detected:

INACTIVE - Detection disabled.

WARNING AND DISABLE - Sends message to Trap Managers and 
disables violated port.