Intermec PF2i User Manual

Connect the antenna cable to the radio module, which is factory-

fitted on the EasyLAN adapter board, as illustrated below. Support 

the upper edge of the radio module with a finger while connecting the 

cable.

Remove the #T20 Torx screw that holds the upper/front part of the 

CPU board to the power supply unit and replace it with the hexagonal 

spacer included in the kit. Keep the screw.
Connect the EasyLAN adapter board to the PCI connector (J84) on 

the CPU board so the hole in the board becomes aligned with the 

spacer and secure the board with the #T20 Torx screw.
Route the antenna cable over the SIMMs on the CPU board towards 

the rear plate and secure it using the cable clips included in the kit. 

One clip is factory-fitted on the EasyLAN adapter board and the 

other should be fitted in the small hole at the top of the CPU board 

immediately to the rear of the memory SIMM sockets.
From the inside of the electronics compartment, insert the antenna 

connector through the round hole in the rear plate and lock it with 

the washer and nut on the outside.
Fit the antenna to the connector of the antenna cable and bend the 

hinge so the antenna points straight up. 
From the outside, insert the thin end of the light guide through the 

small hole next to the antenna on the rear plate. Press the clear plastic 

“lamp” in place. Connect the other end to the black plastic socket 

(D1) at the top of the EasyLAN adapter board. Secure it with the 

cable tie through the hole at the upper edge of the CPU board.

Radio module 

Adapter board

Connect antenna

cable here