Gateway 7210 User Manual

Page of 157
112
          Troubleshooting
The system does not recognize an expansion card
Printer problems
The printer will not turn on
The printer is turned on but will not print
Probable cause
Solution
The interrupt or I/O 
address is set incorrectly
Check the address configuration of the adapter 
card and make sure that it does not conflict 
with another card in the system.
The card has not been 
configured through the 
software
Configure the card with the appropriate 
software.
The card was not 
installed correctly
Make sure the card jumpers are set correctly 
and reseat the card.
Probable cause
Solution
The printer is not turned 
on
Make sure that the power switch is depressed 
or set to the On position. If power is applied 
to the printer, the green power LED should be 
illuminated.
The printer is not 
plugged in
Make sure that the power cable is plugged into 
a live power source.
The printer is defective
Try another printer, if one is available.
Probable cause
Solution
The printer is not 
connected to the system
Make sure the data cable between the printer 
and the system is properly connected. Make 
sure that it is connected to the proper port. 
Make sure the connector and cable have no 
bent or broken pins.
The printer is not 
designated as the default 
printer
If the printer that you are trying to print to is 
not the default printer, make sure that you have 
selected it through the program printer setup 
function.
8505945.book  Page 112  Thursday, March 9, 2000  2:13 PM