Gateway 7210 User Manual
Replacing the hot-plug backplane
75
8
Plug the control panel cable into the connector on the control panel
board.
board.
9
Close the case. (See “Closing the case” on page 27.)
10
Reconnect the power cord and the external peripherals, then turn on the
system.
system.
Replacing the hot-plug backplane
The six drive hot-plug backplane is at the back of the hot-plug drive cage.
The backplane supports as many as six hot-swappable LVD SCSI drives. The
backplane provides activity LEDs for each drive. If the backplane fails, you
must replace it.
The backplane supports as many as six hot-swappable LVD SCSI drives. The
backplane provides activity LEDs for each drive. If the backplane fails, you
must replace it.
To replace the hot-plug backplane:
1
Turn off the system and disconnect the power cord and all external
peripheral devices.
peripheral devices.
2
Open the case. (See “Opening the case” on page 23 and “Preventing static
electricity discharge” on page 22.)
electricity discharge” on page 22.)
3
Disconnect all cables to the hot-plug backplane, noting the connectors
so you can reconnect them after replacing the backplane.
so you can reconnect them after replacing the backplane.
4
Remove all hot-plug drives, being careful to note which drive was in
which slot.
which slot.
5
Loosen the two captive thumbscrews that secure the backplane in the
bracket.
bracket.
8505945.book Page 75 Thursday, March 9, 2000 2:13 PM