Fujitsu BX600 S2 User Manual

PRIMERGY BX600 S2 Basic Unit

 53

Preparation for Use and Operation

V

●

Make sure that the PRIMERGY BX600 S2 basic unit is connected to 
the mains for at least one minute before pressing the power ON/OFF 
button to switch the system ON.

●

If, after switching the basic unit ON, you can only see flickering stripes 
on the attached monitor, switch the system OFF immediately (see 

●

The system ON/OFF power button does not disconnect the system 
from the mains voltage. To completely disconnect it, you must remove 
the power plugs from the sockets.

Ê

Press the basic unit power ON/OFF button (position 2 in 

) for 2 seconds. Depending on the BIOS settings, the server blades 

can be switched on automatically one after another according to the slot 
numbering (see 

Ê

If necessary, switch ON the required server blades (see 

The basic unit is switched ON and the activated server blades perform a system 
test and boot the operating system.

The basic unit is operating (server blades are also switched ON).

Ê

For graceful shutdown of all server blades, press the system power 
ON/OFF button (position 2 on 

) for 4 seconds. The 

server blades will then be powered OFF.

Ê

For hard shutdown of all server blades, press the system power ON/OFF 
button (position 2 on 

) for 10 seconds. The server 

blades will be powered OFF immediately.