Honeywell 1450g User Manual

After transmitting data, the scanner waits for an ACK character (hex 06) or a NAK character (hex 15) response from the 
host. If ACK is received, the communications cycle is completed and the scanner looks for more bar codes.  If NAK is 
received, the last set of bar code data is retransmitted and the scanner waits for ACK/NAK again.  Turn on the ACK/NAK 
protocol by scanning the ACK/NAK On bar code below.  To turn off the protocol, scan ACK/NAK Off.  Default = ACK/NAK 

Off.

The following settings are used to set up communication between Honeywell scanners and bioptic scanners.  

a bioptic scanner.  See  "RS232 Baud Rate" on page 2-18, and 

on page 2-21 for further information.

Packet Mode On must be scanned to set the scanner’s format so it is compatible with a bioptic scanner.  Default = Packet 

Bioptic ACK/Nak On must be scanned so the scanner will wait for an ACK or NAK from a bioptic scanner after each packet 
is sent.  The Scanner-Bioptic ACK/NAK Timeout (below) controls how long the scanner will wait for a response.  Default =