Honeywell 1450g User Manual

If your scanner has been connected directly to an iPad, smart phone, or laptop using 

(page 3-21), you must disconnect it in order to once again communicate with the base or Access Point.  Scan the Blue-
tooth HID Keyboard Disconnect bar code to unlink the scanner from the currently linked host.  Scan the linking bar code 
on the base or Access Point to relink the scanner.

Scanning the Non-Base BT Connection bar code below allows the scanner to be used with other Bluetooth devices (e.g., 
PC/laptop).  When in this mode, the scanner behaves like an RS-232 serial device, and you will need to open a COM port 
on the host to read scanned data.  

After you scan the bar code below, follow the instructions supplied with your Bluetooth device to locate the scanner and 
connect to it.  If you go out of range with your scanner, the scanner will not reconnect to the Bluetooth device when it is back 
in range.  If you want to relink to the charge base or Access Point, refer to 

You may also use the scanner with a PDA or a Honeywell Mobility Systems device.  Scan the bar code below and follow the 
instructions supplied with your Bluetooth device to locate the scanner, and connect with it.  

Some devices require a PIN code as part of the Bluetooth security features.  Your scanner’s default PIN is 1234, which you 
may need to enter the first time you connect to your PDA or PC.  The PIN code must be between 1 and 16 characters.  To 
change the PIN, scan the bar code below and then scan the appropriate numeric bar codes from the 

 

inside the back cover of this manual.  Scan Save to save your selection.

The settings described below can help you customize the relinking behavior of the cordless area-imaging system to obtain the 
best compromise between convenience and low interference.