Honeywell 1450g User Manual

When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released.   Default = Manual Trig-
ger-Normal.

If you wish to set the illumination LED brightness, scan one of the bar codes below.  This sets the LED illumination for the 
scanner when the trigger is pressed.  Default = High.

You can activate the scanner either by pressing the trigger, or using a serial trigger command (see 

10-3).  When in serial mode, the scanner scans until a bar code has been read or until the deactivate command is sent.  The 
scanner can also be set to turn itself off after a specified time has elapsed (see 

, which follows).

Use this selection to set a time-out (in milliseconds) of the scanner’s trigger when using serial commands to trigger the 
scanner.  Once the scanner has timed out, you can activate the scanner either by pressing the trigger or using a serial trig-
ger command.  After scanning the Read Time-Out bar code, set the time-out duration (from 0-300,000 milliseconds) by 
scanning digits on the 

 inside the back cover, then scanning Save.  Default = 30,000 ms.