Toshiba 451C User Manual

306

Printing Guide — Printing from UNIX

If left2right=off then long edge binding is selected, otherwise if left2right=on then short 
edge binding is used.
Example: The command to select left to right page layout for booklet printing mode is 
“lp –o left2right=on filename”.

The booklet mode center margin can be selected using the following options.

Example: The command to select the center margin value for booklet printing mode is 
“lp –o centremargin=value filename”.

The booklet mode outer margin can be selected using the following options.

Example: The command to select the outer margin value for booklet printing mode is 
“lp –o outermargin=value filename”.

The collate option can be selected using the following options.

Example: The command to select collate off is “lp -o collate=off filename”.

left2right=on

ON

Select left to right page layout for booklet printing mode.
This is the default setting.
If the value is ON then the layout of the pages is from 
Left to Right as shown in the figure below.

centermargin
=value

Select the center margin value for booklet printing 
mode.
This value specifies in pixels the Center Margin or the 
“Gutter”. This is in addition to the center margin already 
specified by the application. The valid range for value is 
0 – 300. Default is 0.

outermargin
=value

Select the outer margin value for booklet printing mode.
This value specifies in pixels the Outer Margin or the 
“Creep” per page, which should take place while print-
ing a booklet. The valid range for value is 0 – 18. 
Default is 0.

collate=off

OFF

Cancel the collate printing mode.

collate=on

ON

Set the collate printing mode.