OmniTek 2.3 User Manual

formats other than NTSC are also located on a line other than Line 21. These details are 
recorded on the Teletext/OP-47 page or the Closed Caption page of the Engineering 
Settings control window (see pages 29 and 30).  

 

Reset Status and Logging 

This option offers a way to simultaneously reset the video status, audio status and error 
logging described elsewhere in this user guide. 

 This menu only appears in systems that include the Advanced Audio option. 

 

Enable Playback 

This option ‘connects’ audio from the serial input to the sound output selected within the 
PC. The audio source is selected by clicking on the required channel in the appropriate 
PPM display. 

This menu contains options that affect the video sent to OmniTek XR’s analog 
(monitor) output and SDI outputs. Note that the signal routing options are only 
available where OmniTek XR includes the Motion-Capture module. 

 

Input to Monitor-/Serial-out 

In an appropriately configured system, the monitor output can be set to show either the 
Serial Input or the output from the Generator window. The same choice is independently 
available for the Serial Output.  

These menu options are provided as alternatives to using the drop-down menus on the 
Source toolbar. Ticking the options has the same effect as pointing the Serial Input to the 
monitor and serial output on the Source toolbar, while clearing these options is equivalent 
to setting these outputs to point to the Generator on the Source toolbar. 

Show Crosshair 

OmniTek XR can display a crosshair on the output marking the current point of interest 
(the data for which is shown as the central sample in the Data View window). This menu 
option allows the user to choose whether the crosshair appears on the monitor output, or 
the serial digital output, or on both outputs.